Deprecated: Function split() is deprecated in /home/dangelma/public_html/header.php on line 75

Deprecated: Function split() is deprecated in /home/dangelma/public_html/header.php on line 75
Dangelmayer Associates, L.L.C. - Trusted ESD Control Programs Since 1978 Large Scale ESD Event with a Lightning Strike to a Jet Plane
ESD Class 0 Logo
Lightning Movie     
 
Deprecated: Function split() is deprecated in /home/dangelma/public_html/header.php on line 45
Home > Services >
Enter IntraNet

Deprecated: Function split() is deprecated in /home/dangelma/public_html/left_nav_bar.php on line 42
Language Selection

What's New at Dangelmayer Associates

 
Home
Achievements
About Us
Services
Testimonials
EOS Misdiagnosis
Case Studies
Class 0
Cleanroom ESD - ESD & Contamination Services
Publications
Links
Seminars & Events
Contact Us

DA Class 0 Definition for Manufacturing:

CDM, CBE & Class 0 | Class 0 Case Study | EOS Misdiagnosis

The term Class 0 has not been defined for manufacturing applications by any industry standard and that there is a growing need for one.  We have found that manufacturing failure rates escalate exponentially for devices with ESD withstand voltages below 250 volts for either HBM or CDM and then again at 125 volts and at 50 volts.   Thus, escalation of manufacturing counter measures becomes essential at each of these break points.   It is also vitally important for the manufacturing process to have well defined trigger points for risk assessments of these ultra-sensitive components. These risk assessments involve verification of manufacturing process capability as well as for any risks that may be passed on to customers.  In some instances, risk assessments have resulted in the redesign of components, circuit boards and/or assemblies to improve the ESD performance.  Manufacturing process capability tests become increasingly complex the deeper into the Class 0 region the devices are (see Class 0 case study).    Note: MM is intentionally omitted from this definition since it is largely redundant to HBM.

Thus, we define Class 0 for manufacturing as any component that falls into one of the three categories below.   Control methods escalate with each lower category.  

  • Class 0
    • Component Withstand Voltages Less than 250 volts HBM or CDM
       
  • Class 00
    • Component Withstand Voltages Less than 125 volts HBM or CDM
       
  • Class 000
    • Component Withstand Voltages Less than 50 volts HBM or CDM
       

 


Strict Standards: Only variables should be passed by reference in /home/dangelma/public_html/services/class_0/class-0-definition.php on line 132

Strict Standards: Only variables should be passed by reference in /home/dangelma/public_html/services/class_0/class-0-definition.php on line 133